A damaged garage door cable can leave the door tilted, stuck, or hanging on one side. Keep the door out of use if it is uneven, and do not handle the bottom brackets; those parts carry spring tension.
In the Valley of the Sun, the lift system still depends on cables following their intended paths. On torsion-spring doors, cables run from the lower brackets to drums on the shaft above the door. Extension-spring systems use pulleys instead. A cable can fray, rust, or jump out of position, while a spring or another worn part may also affect how the door lifts.
Our crew examines both cables, the drums or pulleys, spring condition, and nearby hardware to locate the problem. We unload spring tension before removing cables, install a correctly sized pair, and set them in their proper paths. Then we adjust the lift and test the door. Our truck carries common cable sizes, clamps, and winding bars for this work.
Signs You Need Garage Door Cable Repair
- One bottom corner hangs lower than the other.
- My garage door is tilted when it stops.
- I can see a loose cable near the track.
- The door catches or jerks while moving.
- One side starts rising ahead of the other.
- I heard a snap, and now the door will not lift.
The Kierland Heat Factor
If your garage door sits unevenly or feels heavier than usual, stop operating it and have us inspect the cable system. Summer afternoons here average about 105°F, and about 173 days a year reach 90°F or hotter. That heat is part of the garage environment, but it cannot show whether a cable has frayed, slipped, or lost proper alignment. Our crew checks the cable strands, winding drums or pulleys, and nearby spring parts for wear or damage. We base the repair on what we find, not on the temperature alone.
How We Handle It
Tell us what happened
A person from our crew takes your call and asks how the door sits, sounds, and moves. We note any cable you can see hanging or out of place.
Inspect and quote
We examine the cables and related lift parts at your home. We explain the work and give you the exact quote before starting.
Repair the lift cables
We unload spring tension, remove the damaged cables, and fit a correctly sized pair. We set the cables in their paths and adjust the lift.
Check safe operation
Before leaving, we test the door's balance and safety reversal. We run the door through its travel and check for binding or uneven movement.
Starting Prices — Garage Door Cable Repair
- Garage Door Cable Replacement per cable
- From $150
- Diagnostic Service Call $0 with a completed repair
- $0
Starting prices. A door has two lift cables and one or two springs; the exact price depends on the door, the hardware grade and how many parts are replaced, and is confirmed on site before any work starts.